Monitoring system for distributed objects
To create IT-monitoring of the health of distributed, it is recommended to use a solution from several Camkeeper software and hardware complexes.
Objects with "white" IP-addresses can be connected to one Camkeeper ("central"), which will be located in the monitoring center.
For objects with "gray" IP-addresses, it is recommended to install Camkeeper in the "data collector" format, which collects monitoring data and sends it to the central Camkeeper.
If there is a risk of replacing / adding routers at sites with "white" IP-addresses, then it is recommended to install Camkeeper on them in the "data collector" format as well.
- Stable monitoring of the health of facilities without port forwarding at facilities and the installation of additional routers.
- Ease of customization. Camkeeper is a ready-made, pre-configured IT monitoring solution. Launching does not require any special knowledge. System setup takes 30 minutes.
- Trust relationship between the customer and the contractor. Both parties see the same interface, receive the same notifications and use the system to improve their business.
The system is working! Rate the work of the security system in one glance
The clarity of working with the plans of the facility is primarily relevant for the security service. An understanding of the weaknesses of the security system immediately appears, to see exactly where the defective equipment is located, and, if necessary, allows you to make the right decision to strengthen a specific section.
Full control over the system at any time
The health report for each device is automatically generated by the system and is available for viewing at any time. Camkeeper allows you to instantly respond to emerging problems, as well as conduct a comprehensive analysis of the interaction of equipment with each other.
Instant notifications
Camkeeper compares the received metrics from devices to match the template every 30 seconds.
In the event of deviations in monitored devices (abnormal operation), Camkeeper double-checks the data and, if the incident is confirmed, notifies by all available means.
Camkeeper can notify by e-mail, SMS, Telegram bot. The user himself defines the recipients of notifications.
Notifications contain information about the defective device, the nature of the error, and the time of occurrence.
If the error is corrected, Camkeeper will check 5 times and send a notification about the correction of the situation.
Safely
Camkeeper is an on-premises solution. System health data is not sent to the cloud to third parties and is only available to the user.
Camkeeper has no effect on the overall performance of the monitored system.
Has a built-in modem for independent notification and built-in sensors that monitor the state of the environment.
standard for smart IT monitoring
The system allows you to significantly reduce the cost of maintaining the security system due to the rapid identification of emerging problems.
In case of malfunctions of elements of the video surveillance system, Camkeeper gives precise recommendations for their elimination.
Full control of occurrence and troubleshooting.
Connection is made in 1 action!
Cheaper, faster, more reliable
Camkeeper is a ready-made, pre-configured health monitoring solution. Implementation takes significantly less time and does not require fine tuning and modifications, and is also much cheaper than available similar monitoring solutions.
- Interoperability over various data transmission protocols, including RTSP and SNMP < / span>
- Easy start-up: no special knowledge required to start
- Specialization for security systems
- Ready Russified hardware and software solution
- Built-in data link
- Certified solution, technical support
- Connecting an external antenna for signal amplification and data transmission
- Integration with CRM
- Notification via e-mail, SMS, Telegram
- The presence of a structural (logical) interactive map
- Overlay of device icons on the BTI plan, geographic map
- 80 pre-configured device control templates
- Support for all manufacturers of equipment for security systems
1999 $
30 minutes setup